RTP Company Wear Resistant Thermoplastics Compounds

Wear Resistance Data
(Standard English)

RTP 882 TFE 10
versus 1018 C Steel

Acetal (POM)
Carbon Fiber 15%
PTFE 10%

PV	Load	Speed	Wear Factor X 10E-10	µ dynamic
2000	8	50	160	0.3
5000	10	100	219	0.4
10000	10	200	303	0.57

Data obtained using ASTM 3702.
PV units: lb ft/in² min
Load units: lb
Speed units: ft/min
Wear Factor units: in³ min/lb/ft/hr
Data last revised: April 2001

RTP 800 Series
Acetal
Compounds

Advantages
• Resistance to creep and fatigue
• Rigidity and resilience
• Resistance to solvents

Limitations
• High specific gravity
• Anisotropic shrinkage
• Processing difficulties

Acetals are rigid, creep resistant and strong. They possess low coefficients of friction. They remain stable in high temperature service and offer exceptional resistance to hot water environments.

They are virtually unaffected by strong bases but are attacked by strong mineral acids.

A 40% glass reinforced acetal has a flexural modulus of 1.6 psi x 10E-6 (11024 MPa) and 330 degrees F (166 degrees C) heat deflection temperature.

No information supplied by RTP Company constitutes a warranty regarding product performance or use. Any information regarding performance or use is only offered as suggestion for investigation for use, based upon RTP Company or other customer experience. RTP Company makes no warranties, expressed or implied, concerning the suitability or fitness of any of its products for any particular purpose. It is the responsibility of the customer to determine that the product is safe, lawful and technically suitable for the intended use. The disclosure of information herein is not a license to operate under, or a recommendation to infringe any patents.

[ POM Resin System | Wear CD Start | Web CD Start ]