Wear Resistance Data
(Standard English)
RTP 2800-35A TFE 20
versus 1018 C Steel
|
Olefinic Thermoplastic Elastomer (TEO)
35-A Durometer
PTFE 20%
|
|
PV
|
Load
|
Speed
|
Wear Factor
X 10E-10
|
µ dynamic
|
| 250 |
1 |
50 |
13548 |
1.63 |
| 500 |
2 |
50 |
17744 |
1.23 |
|
Data obtained using ASTM 3702.
PV units: lb ft/in2 min
Load units: lb
Speed units: ft/min
Wear Factor units: in3 min/lb/ft/hr
Data last revised: April 2001
|
|
|
RTP 2800 Series
Olefinic Thermoplastic Elastomer
Compounds
Advantages
• Moderately low cost
• Good chemical and oil resistance
• Compression set resistance
Limitations
• Moderate heat resistance
• Do not accept large amounts of fillers
The olefinic elastomers are a good compromise between price and performance. They have good chemical resistance against water, acids and bases.
When exposed to hydrocarbons such as fuel and oil, they will have good property retention but experience swelling. Service temperature is from -60 to 275 degrees F (-51 to 99 degrees C). Hardness ranges from 35 Shore A to 50 Shore D.
|
|
|
No information supplied by RTP Company constitutes a warranty regarding product performance or use. Any information regarding performance or use is only offered as suggestion for investigation for use, based upon RTP Company or other customer experience. RTP Company makes no warranties, expressed or implied, concerning the suitability or fitness of any of its products for any particular purpose. It is the responsibility of the customer to determine that the product is safe, lawful and technically suitable for the intended use. The disclosure of information herein is not a license to operate under, or a recommendation to infringe any patents.
|
[ TEO Resin System | Wear CD Start | Web CD Start ]
Copyright © 2001, RTP Company
E-mail rtp@rtpcompany.com
|
![[RTP Company]](../../graphics/masthead.gif)